Advertisement
ASSEMBLY & SET-UP
• With spring loaded lid closed, place Tub unit [A] upside down
on a non-scratching surface (cardboard, carpet etc.).
• Attach each of the 4 legs [B] with 4 sets each of 6mm
screws, lockwashers and nuts to the brackets on the Tub
unit (FIG 1). Tighten with a 10mm wrench and either a large
Phillips or Straight Blade screwdriver (not included).
• Attach Storage Shelf [C] to holes located mid-way of the 4
legs [B] with 2 sets each of 6mm screws, lockwashers and
nuts (FIG 2). Tighten with a 10mm wrench and either a large
Phillips or Straight Blade screwdriver (not included).
• With the aid of a helper, flip the entire unit right side up onto
it's feet and carefully open the spring loaded lid.
• Grasp Pump Box Assembly [D] with the Switch Box upward
and facing outward then pass the Power Cord and Switch Box
through the rectangular cutout at the upper right rear wall of
the Tub (FIG 3).
To order parts and supplies: 800.343.9353 >> eastwood.com
FIG. 1
B
FIG. 2
FIG. 3
B
A
B
C
5
Advertisement
