SentexSystems HORIZON Instruction Manual page 19

ON-SITE RELAY ACTIVATION
The first step for on-site relay activation is to enter the programming mode via your programming
source. Next, you will enter the appropriate code for the relay you wish to activate. The codes for controlling
the system's relays are as follows:
TIMED RELAY ACTIVATION (activation time is established in area 02)
RELAY 1 = 99 + ENTER
RELAY 2 = 95 + ENTER
The system will not display a direct response to these entries - it will simply display a "fresh"
programming prompt. However, the action you desired will be carried out immediately.
SUSTAINED RELAY ACTIVATION (stays activated until released by operator)
RELAY 1 = 98 + ENTER
RELAY 2 = 94 + ENTER
The unit will respond with "LATCH OPEN DOOR - ARE YOU SURE (1=YES, 0=NO) __". If you
respond with a "0", nothing will happen. If you respond with a "1", the appropriate relay will be activated until
you "unlatch" it by initiating a timed activation of the same relay as described above.
PLEASE NOTE: If relay 2 is set to operate as an alarm relay, you will not be able to operate it on
either a timed or sustained basis.
Rev B Doc. 6001036 Page 17 of 20