Specifications - Makita BO5030 Instruction Manual

ENGLISH (Original instructions)
1-1. Switch
2-1. Speed adjusting dial
4-1. Dust bag
5-1. Dust nozzle
6-1. Dust nozzle
7-1. Groove

SPECIFICATIONS

Orbits per minute (min
Dimensions (L x W x H)
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for the sanding of large surface of
wood, plastic and metal materials as well as painted
surfaces.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
For Model BO5030
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
Wear ear protection.
Vibration
The vibration total
determined according to EN60745:
Work mode : sanding metal plate
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Explanation of general view
7-2. Front fixing cardboard
7-3. Front side of paper dust bag
8-1. Claws
8-2. Upper part
9-1. Notch
9-2. Guide
Model
Paper size
-1
)
Net weight
Safety class
) : 80 dB(A)
pA
value (tri-axial vector
2
) : 4.5 m/s
h
2
BO5030
125 mm
12,000
153 mm x 123 mm x 153 mm
1.3 kg
ENE052-1
For Model BO5031
Noise
The typical A-weighted noise level determined according
to EN60745:
ENF002-1
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
Vibration
The vibration
determined according to EN60745:
Work mode : sanding metal plate
Vibration emission (a
Uncertainty (K) : 1.5 m/s
ENG104-2
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
ENG211-2 WARNING:
The vibration emission during actual use of the
•
sum)
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
3
11-1. Holding tab
12-1. Dust box
12-2. Dust nozzle
13-1. Latch
13-2. Dust nozzle
153 mm x 123 mm x 153 mm
/II
) : 80 dB(A)
pA
Wear ear protection.
total value (tri-axial
) : 4.0 m/s
h
2
BO5031
125 mm
4,000 - 12,000
1.3 kg
/II
ENG104-2
ENG211-2
vector sum)
2
ENG901-1