Regulatory Information - XBOX One Product Manual

Using the Xbox One in an environment where the external
temperature varies widely and quickly might damage the
console. When moved to a location with a temperature
difference of 20 degrees or more from the previous location,
allow the console to come to room temperature before turning
it on. The console's operating temperature is +5ºC (+41ºF) to
+35ºC (+95ºF).
WarnInG: Hearing safety
Extended exposure to high sound volumes when using a headset
may result in temporary or permanent hearing loss. To reduce
the risk of hearing loss, set the volume loud enough to hear
clearly in quiet surroundings, and no louder.
• D o not increase the volume after you start listening. Your
ears can adapt over time so that high volume sounds normal,
but the high volume may still damage your hearing.
• D o not increase the volume to block out outside noise.
The combination of outside noise and sound from your
headphones can damage your hearing. Sealed or noise-
canceling headphones can reduce outside noise so that you
don't have to turn up the volume.
• I f you can't understand someone nearby speaking normally,
turn down the volume. Sound that drowns out normal
speech can damage your hearing. Even with sealed or noise
canceling headphones, you should be able to hear nearby
people speak.
minimize your time listening to loud sound.
• T he more time that you spend exposed to high sound
volumes, the more likely you are to damage your hearing.
The louder the sound, the less time that is required to
damage hearing.
• A t maximum volume, listening to music on the device with
headphones can permanently damage your hearing in 15
minutes. Even lower volumes can damage hearing if you are
exposed to it for many hours. All of the sound that you are
exposed to during a day adds up. If you are exposed to other
loud sound, it takes less time listening at high volumes to
cause hearing damage.
• T o safely use the device without a time limit, keep the volume
low enough that you can carry on a conversation with people
nearby.
CaUTIon: Personal medical devices
Radio-frequency emissions from electronic equipment can
negatively affect the operation of other electronic equipment,
causing them to malfunction. Although the device is designed,
tested, and manufactured to comply with regulations governing
radio frequency emission in countries such as the United States,
Canada, the European Union, and Japan, the wireless transmitters
and electrical circuits in the device may cause interference
in other electronic equipment. Always take the following
precautions:
Persons with pacemakers
• T he Health Industry Manufacturers Association recommends
that a minimum separation of 6 inches (15 cm) be
maintained between a wireless device and a pacemaker to
avoid potential interference with the pacemaker.
• W ireless devices should not be carried in a breast pocket.
• I f you have any reason to suspect that interference is
occurring, turn the device off immediately.
other medical devices
If you use any other personal medical device, contact the medical
device manufacturer or your physician to determine whether it
is appropriate for you to use other electronic devices near your
medical device.
4
one-year LImITed WarranTy WITH arbITraTIon
CLaUse and CLass aCTIon WaIVer
Microsoft warrants that your Xbox One console and Kinect sensor
will not malfunction under normal use conditions for 1 year
from the date you purchased it. The warranty excludes normal
wear and tear, and damage caused by accident or abuse. other
exclusions and limitations apply, including merchantability.
To obtain service, call Microsoft at (800) 4MY-XBOX (469-9269)
or go to xbox.com/xboxone/support. Please read the entire
Limited Warranty, including more information about obtaining
service, at xbox.com/xboxone/warranty. You may read and email
a copy to yourself during product registration.
If you live in the United states, section 9 of the Limited
Warranty contains a binding arbitration clause and class action
waiver, available at xbox.com/xboxone/warranty/arbitration.
The arbitration clause affects your rights about how to resolve
a dispute with microsoft. Please read it. Parts of the arbitration
clause are described below.
Any dispute not resolved by informal negotiation or in small
claims court will be resolved only by individual binding
arbitration under the Federal Arbitration Act before a neutral
arbitrator whose decision will be final—not before a judge or
jury, and not in a class action lawsuit or a class, representative, or
private attorney general proceeding of any kind. The American
Arbitration Association will conduct the arbitration under its
Commercial Arbitration Rules. The Limited Warranty's arbitration
clause contains the rest of the terms, instructions, and forms for
notifying Microsoft of a dispute or commencing arbitration.

reGULaTory InformaTIon

• N ot intended for use in machinery, medical or industrial
applications.
• A ny changes or modifications not expressly approved by
Microsoft could void the user's authority to operate this device.
• T his product is for use with NRTL Listed (UL, CSA, ETL, etc.),
and/or IEC/EN 60950-1 compliant (CE marked) Information
Technology equipment.
• N o serviceable parts included.
• T his device is rated as a commercial product for operation at
+5ºC (41ºF) to +35ºC (+95ºF).
To comply with RF exposure requirements, the following operating
configurations must be satisfied: the antenna has been installed
by the manufacturer and no changes can be made. The wireless
devices must not be co-located or operating in conjunction with
any other antenna or transmitter. Except for headset and handheld
devices, wireless devices must be at least 20 cm (8 inches) between
the antenna of the wireless device and all persons.
for 802.11a and 802.11n 5GHz devices only
This product is restricted to indoor use only to reduce any
potential for harmful interference with licensed operation in the
5.15 to 5.25 GHz frequency range.
Microsoft Corporation; One Microsoft Way; Redmond, WA
98052-6399; U.S.A. United States: (800) 426-9400; Canada:
(800) 933-4750.
This Class B digital apparatus complies with Canadian ICES-003,
RSS-Gen, RSS-210 and RSS-310 of Industry Canada (IC). Operation
is subject to the following two conditions: (1) this device may
not cause interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
This Class B digital apparatus complies with Canadian NMB
003, CNR Gen, CNR 210 and CNR 310 of Industry Canada (IC).
Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must