Advertisement
Available languages
Available languages
Absolute Phono
User manual / Bedienungsanleitung
1. Installation and set-up
Before you start, make sure that the tonearm is correctly installed on your turntable and is equipped
with the Clearaudio Absolute Phono headshell
and Clearaudio Direct Silver Wire with the special 9–pin
connector.
To proceed with installation and set-up, please see the rear panel of your Clearaudio Absolute Phono.
Rear view:
3
1
2
2
Pic.1: Absolute phonostage (rear view)
Please proceed as follows:
1. Connect the special 9-pin connector from the tonearm to the input marked "input amplifier"
and gently secure with the two locking screws. Please make sure that the screws are properly
tightened and thus the plug is securely connected
2. Plug the RCA or XLR cable into the output sockets and connect them to your linestage preamplifier.
3. Connect the power supply provided to the socket marked "DC in", "6V", then connect this power
supply to your mains power supply.
Important: Please note that you may only use power supplies with a voltage of 6V DC!
4
Pic.2: Absolute phonostage (front view)
4. Lightly press the push button on the front of the Absolute Phono. The blue LED ring will flash
approximately seven times and then glow steadily.
Your Clearaudio Absolute Phono is now ready to use and enjoy.
Page / Seite 3
Clearaudio Electronic GmbH 2013
Advertisement
