Ceiling Mounting; How To Use - Swann SH16340N Manual

Ceiling mounting is the same method as wall mounting. Please ensure the wall or
ceiling is sturdy enough to take the weight of the heater. Always take extra care
when using ladders etc. Wear appropriate safety goggles when drilling.
Insert 2 x AAA batteries (not included) in the remote control unit. Please carefully
observe correct polarity. Remove spent batteries to prevent battery corrosion from
damaging the remote. Always use good quality, branded batteries.
1. Plug in the unit to a 220-240V 13 Amp AC socket
2. Press Switch on left side of the heater. LED indicator light stars flashing show-
ing the heater is on standby. Press ON button on control panel (or ON button
on remote control) to switch on the heater. To shift the heater to standby
mode, press OFF button on control panel (or OFF button on remote control).
LED indicator light will start flashing again.
3. To switch off the heater, press Switch on left side of the heater accordingly.
SH16340N_IM.indd 7

CEILING MOUNTING

HOW TO USE

7
21/02/2019 10:21