Table of Contents
Advertisement
Fig. A
4.
Unscrew the Screw Nuts (5) and set them aside with Washers (3) and Spring Washers
(4) for use later.
5.
Put Steel Board (2) onto the ceiling or wall. Put 4 Expansion Bolts go through the 4
holes on Steel Board and fix it with the Washers, Spring Washers and Screw Nuts that
you removed earlier
6.
Mount Upper Bracket (7) on Lower Bracket (9). Screw it tightly with Screw M8*70 (10)
as shown on Fig. A.
7. For wall-mounted vertical installation, the switch panel needs to be
lower most so rising heat doesn't damage the switch panel or power
cord
8.
Mount the heater onto the wall or ceiling by sliding Upper Bracket into the opening on
the Steel Board. Fix them together with 2 Screw Knobs M6*12 (6).
9.
Use a screw driver to loosen the Screw M8*70 (10) a little bit. Set the heater to a
desired angle then tighten it again.. The adjustable angle is within 60 degrees. Fig.D
SH16340N_IM.indd 6
WALL MOUNTING
1.
2.
3.
6
The heater must be installed
at least 1.8m from the
ground and at least 50cm
from any side wall or ceiling.
Drill 4 holes on the ceiling
or wall according to the size
shown on Fig. B. Insert the 4
Expansion Bolts (1) into the
holes.
Use a spanner to tighten the
Nuts on the Expansion Bolts
clockwise till they are securely
located in the holes.
21/02/2019 10:21
Advertisement
Table of Contents
