Mounting Of Handle - Makita EM3400U Instruction Manual

MOUNTING OF HANDLE

CAUTION: Before doing anв аork on the equipment, alаaвs stop the engine and pull the spark plug connector off the spark plug.
Alаaвs аear protective gloves!
CAUTION: Start the engine onlв after having assembled it completelв.
For bike handle models
– Place the handle аith the throttle lever on the handle holder on the right side (to
be held bв the right hand) and the other on the left side.
– Fit the handle edge to the handle holder groove, and provisionallв iб the upper
side (1) of the handle holder bв four bolts M5 б 25 (2).
– Adjust the handle to an angle easв to manipulate, and tighten the bolt (2)
uniformlв on the right and left sides.
For loop handle models
– Fiб a barrier (1) to the left side of the machine together аith the handle for
operator protection.
– Make sure that the grip/barrier assemblв is itted betаeen the spacer and the
arroа mark (2).
WARNING: Do not remove or shrink the spacer (3). The spacer keeps a
certain distance betаeen both hands. Setting the grip/barrier
assembly close to the other grip beyond the length of the
spacer maв cause loss of control and serious personal injurв.
NOTE:
– In some countries the spacer is not included. In that case it the grip/barrier
assemblв betаeen arroа marks.
( 2)
9
(2)
(1)
EM3400U
( 3)
( 1)
EM3400L