Replacing The Line; Need Assistance; Accessories Available - Weed Eater 530086306 Operator's Manual

SERVICE

REPLACING THE LINE

S Disconnect unit from the power
source.
S Remove the spool by firmly pulling on
the tap button.
S Clean entire surface of hub and spool.
S Replace with a pre-wound spool or
cut a length of 30 feet of 0.065 inch
(1.65 mm) diameter Weed
brand line. Use of heavier lines could
overload and damage unit.
WARNING:
Never use wire, rope,
string, etc., which can break off and be-
come a dangerous missile.
S Insert one end of the line about 1/2
inch (1 cm) into the small hole inside
the spool.
Small
Hole
Tap
Button
S Wind the line evenly and tightly onto
the spool. Wind in the direction of the
arrow found on the spool.
S Push the line into the notch, leaving 3
to 5 inches (7 -- 12 cm) unwound.
S Insert the line into the exit hole in the
hub as shown in the illustration.
Line in Notch
Hub
Line exit hole
S Align the notch with the line exit hole.
S Push the spool into the hub until it
snaps into place.
S Pull on the line extending outside the
hub to release it from the notch; other-
wise, the unit will not function properly.
STORAGE
WARNING:
steps after each use.
S Stop the unit and disconnect the pow-
er source when not in use.
S Carry the unit with motor stopped.
S Store the unit so the line limiter blade
cannot cause injury.
Eaterr
S Store unit and extension cord indoors
in a high, dry place out of the reach of
children. Store unit unplugged.
S Store unit with all guards in place.
Position unit so that any sharp object
cannot accidentally cause injury.

NEED ASSISTANCE?

For assistance or a replacement part,
call 1 800 554
-- --
Spool

ACCESSORIES AVAILABLE

Safety Glasses
Spool with 30! line
50! coil of bulk line
100! coil of bulk line
200! coil of bulk line
6
Perform the following
6723.
--
952701645
952701663
952701550
952701533
952701594