Table of Contents
Advertisement
Available languages
Available languages
.
English
Warning: Do NOT leave the charger
plugged in for longer than 5 hours. The
battery will be fully charged within one
hour. Leaving the charger plugged in for
longer than 5 hours may damage the
battery.
Inserting a Bit into the Bit Connector:
Push forward metal collar and insert any ¼ in.
hex shank accessory. Release the collar to
lock the accessory in the bit connector (7).
Removing a Bit from the Bit Connector:
Push forward the metal collar to release the
accessory from the bit connector.
LED Worklight
This driver has a LED worklight (1) built into the
head of the tool. Turn the LED bulb towards the
direction of the connector to turn on. The light
will remain on while it is in the same direction
as the connector. To turn off the light, turn the
LED bulb towards the battery compartment (2).
Replacing the Worklight Battery
Remove the battery cover (2) and replace the
battery with a new one (CR927). Please
observe correct polarity, the positive pole (+) of
the battery must point to the battery compart-
ment cover.
Forward/Reverse Switch
The forward/reverse switch (3) is conveniently
mounted below the trigger switch (5). To make
the driver rotate clockwise for driving screws,
push the forward/reverse switch to the left. To
make the driver rotate counter clockwise for
removing screws, push the forward/reverse
switch to the right.
Notes:
a.
Never change the position of the forward/
reverse switch while the driver is turning.
b.
The trigger switch will NOT function
with the forward/reverse switch in the
middle/neutral position.
Variable Speed Trigger Switch
The cordless driver is equipped with a varia-
ble-speed trigger switch.
1.
To start the driver, gently squeeze the
trigger switch (5).
NOTE: The driver will turn at its slowest speed
when the trigger switch is squeezed lightly. The
driver will turn at its fastest speed when the
trigger switch is squeezed firmly.
14
7062267_FlipOut_Ma_#1605-04.indb 14
2.
To stop the cordless driver, release the
trigger switch.
NOTE: Operating the driver at a slow speed for
an extended period of time may cause the
driver motor or the battery to overheat. If the
driver gets hot, stop operating it and allow it to
cool for at least 15 minutes.
Multi-Position Driver Head
The cordless driver has a multi-position head.
This allows the connector to move in any direc-
tion required.
1.
To rotate the head 360º, push the switch
(6) towards the connector and freely rotate
the head.
2.
To change the angle of the driver head
push button (13) and rotate the angle of
the head.
3.
To change the angle of the connector
push button (12) and rotate the head.
MAINTENANCE AND CLEANING
Maintenance
There are no inner parts of the tool which need
maintenance.
Cleaning
•
Keep safety devices, ventilation openings
and the motor housing as free as possible
from dirt and dust. Rub the electric power
tool with a clean cloth or blow over it with
low pressure compressed air.
•
We recommend that you clean your elec-
tric power tool immediately after each use.
•
Clean the electric power tool regularly with
a damp cloth and somewhat soft soap. Do
not use any cleaning or solvent materials;
these can attack the device's plastic com-
ponents. Make sure that no water can get
inside the electric power tool.
06-05-16 09:33
Advertisement
Table of Contents
