Accessories; Maintenance And Cleaning - Batavia BT-CBCD002 Operating Instructions Manual

English
played on the torque ring, the higher the
torque produced by the tool.
Speed setting
7.4
The machine has 2 drill speeds, which can
be adjusted by sliding the gear switch (5)
forward or backwards. The number on the
gear switch (5) shows which position is
chosen.
Selection:
7.5
Screwing
Drilling Masonry /
Concrete
Drilling Wood
Drilling Metal
*
• Select a low setting for small screws or
soft work material.
• Select a high setting for large screws,
hard work materials and when remov-
ing screws.
• You should preferably choose a setting
as low as possible when driving screws.
Select a higher setting if the motor slips
before the screw is fully tightened.
WARNING: If the power tool gets exces-
sively hot in use, stop using the tool immedi-
ately and allow to cool before continuing
work. The cooling period can be reduced by
operating the drill at maximum speed with
no load. Always make sure the Motor Vents
(6) are not blocked and do not allow dust to
enter the body of the tool through the Motor
Vents; dust, especially metallic dust, may
damage or destroy the tool.
Switching the machine on and off
7.6
The on/off switch (13) is used for activating
the machine and adjusting rotation speed.
• Pressing the on/off switch (13) will
activate the machine, the further the
switch is being pushed, the faster the
drill will turn.
• Releasing the on/off switch (13) will
stop the machine.
8
Mode selector
Position 1: For slow drilling, large drilling
diameter or screw driving. The machine has
higher torque at a low speed.
Position 2: For fast drilling or small drilling
diameter. The machine has lower torque at
a high speed.
Torque selector
1 – 16 *
N/A
N/A
N/A
LED lamp
7.7
The LED lamp (14) will be lit automatically
as soon as you press the ON/OFF switch
(13).

8. Accessories

Use only accessories with an allowable
speed matching at least the highest no-load
speed of the tool.

9. Maintenance and Cleaning

WARNING: Always disconnect from the
mains power supply, before carrying out any
maintenance/ cleaning of the charger.
Remove the battery before carrying out any
maintenance/cleaning of the tool.
Maintenance
9.1
There are no inner parts of the tool which
need maintenance.
Cleaning
9.2
• Keep safety devices, ventilation open-
ings and the motor housing as free as
possible from dirt and dust. Rub the
electric power tool with a clean cloth or
blow over it with low pressure com-
pressed air.
• We recommend that you clean your
electric power tool immediately after
each use.
• Clean the electric power tool regularly
with a damp cloth and somewhat soft
soap.
Speed
1
2
1 or 2
1 or 2