Blade Cutting Adjustment; Start/Stop - Texas A/S Spinner CM01 User Manual

9. Blade cutting adjustment

Remove battery and safety key before
adjusting blade.
To adjust he blade tighten the 2 nuts on the blade
shield..
To check for correct adjustment, insert a piece of
paper between the blade and the cutting cylinder.
When the cutting cylinder is turned by hand the
paper should be cut cleanly.
Blade is already adjusted from the factory.
Only adjust if necessary. Use the included tool for
this purpose.

10. Start/stop

The handle is designed with a safety button
to prevent accidental starting.
Press and hold the safety button A, then
squeeze the start lever B towards the upper
handle. Then release A.
Release the start/stop lever B to stop the
machine.
When releasing the lever to stop the
engine wait for the blades to stop turning
before touching the blade..
www.texas.dk
18