Electrolux ERW3313AOX User Manual page 11

Hide thumbs Also See for ERW3313AOX:
Table of Contents

Advertisement

Available languages

Available languages

Problem
The lamp does not work.
The compressor operates
continually.
Water flows on the rear
plate of the refrigerator.
Water flows inside the
wine cellar.
DEMO appears on the dis‐
play.
If the advice does not lead to
the desired result, call the
nearest brand-mark service.
6.2 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to "Installation".
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
Possible cause
The temperature in the
appliance is too high.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor‐
rectly.
Many products were put
in at the same time.
The room temperature is
too high.
Products placed in the
appliance were too
warm.
The door is not closed
correctly.
During the automatic de‐
frosting process, frost
melts on the rear plate.
The water outlet is clog‐
ged.
Products prevent that
water flows into the water
collector.
The appliance is in dem‐
onstration mode.
6.3 Replacing the lamp Wine
Cellar
1. Disconnect the mains plug from the
2. Remove the lamp cover by pressing
Solution
Contact a qualified electri‐
cian or contact the nearest
Authorized Service Centre.
Close and open the door.
Refer to "Replacing the
lamp".
Refer to "Operation" chapter.
Wait some hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow products to cool to
room temperature before
storing.
Refer to "Closing the door".
This is correct.
Clean the water outlet.
Make sure that products do
not touch the rear plate.
Keep the Light pressed for
approximately 10 seconds
until a long sound is heard
and display shuts off for a
short time.
mains socket.
it inwards with a tool (e.g.
screwdriver) to free the rear side
hookings.
ENGLISH
11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents