Feed Dog Adjustment - ELNA Elnita ec60 Service Manual

MECHANICAL ADJUSTMENT

FEED DOG ADJUSTMENT

The highest position of the feed dog should be parallel to the surface of the needle plate.
If not, adjust as follows.
1. Use a hexagonal socket screw (4 x 6).
Insert the screw to the hole B. Tighten the hexagonal socket screw as far as it goes.
2. Loosen the setscrew C.(left screw)
3. Turn hexagonal socket screw to adjust the feed dog (should be parallel to the surface of the needle
plate).
4. Tighten the setscrew C (left screw).
5. Loosen the hexagonal socket screw and remove it.
Setscrew C (left screw)
15
Hexagonal socket screw 4x6
Hole B