After Each Use; Seasonal Storage - Weed Eater 545117528 Instruction Manual

Switch -- Ensure switch func-
ON/OFF
S
tions properly by moving the switch to
the position. Make sure motor
OFF
stops; then restart motor and continue.
S Inlet Cover -- Discontinue use of unit if
inlet cover fails to latch properly or if it is
damaged in any way.

AFTER EACH USE

INSPECT AND CLEAN UNIT & LABELS
Stop unit and unplug extension cord.
S After each use, inspect complete unit
for loose or damaged parts. Clean the
unit using a damp cloth.
S Wipe off unit with a clean dry cloth.
HOW TO REMOVE AN OBJECT
FROM THE AIR INTAKE
WARNING:
Stop the unit and dis-
connect from the power source before
opening the inlet cover. The motor must
be stopped and the impeller blades no
longer turning to avoid serious injury
from the rotating blades.
WARNING:
Perform the following
steps after each use:
S Stop unit and disconnect from the pow-
er source.
S Allow motor to cool before storing or
transporting.
S Store unit with all guards in place. Posi-
tion unit so that any sharp object cannot
accidentally cause injury.
S Store unit unplugged, well out of the
reach of children.

SEASONAL STORAGE

Prepare unit for storage at the end of
the season or if it will not be used for
30 days or more.
CLEAN COLLECTION BAG
IMPORTANT: THE COLLECTION BAG
MUST BE PROPERLY EMPTIED.
You must properly empty and maintain
D
the collection bag to avoid deterioration
and obstruction of air flow.
Remove the collection bag from the unit
D
and empty after each use. Do not store
bag without emptying the bag of all con-
tents (grass, leaves, etc.).
Wash the bag once a year. Remove the
D
bag from the blower and turn the bag in-
side out. Wash the bag with a water
hose. Allow the bag to hang and dry
completely before you reuse the bag.
SERVICE
1. While holding the inlet cover open,
remove the vacuum tubes. The inlet
cover must be held open through all
remaining steps.
2. Carefully reach into the vacuum
opening and clear out the air intake
area. Clear all debris from impeller.
3. Inspect the impeller for cracks. If
cracked or damaged, do not use the
unit. Have parts replaced by your au-
thorized service dealer. Do not at-
tempt to replace them yourself.
STORAGE
If your blower is to be stored for a period
of time:
S Stop unit and disconnect from the pow-
er source.
S Clean the entire unit before lengthy stor-
age.
S Open inlet cover and clean any dirt,
grass, or debris that has collected. In-
spect the blower and all tubes. Close
and make sure the cover is latched.
S Clean air vents and air inlet of debris.
S Store your unit and extension cord in a
well ventilated area and covered, if pos-
sible, to prevent dust and dirt accumula-
tion. Do not cover with plastic. Plastic
cannot breathe and may cause con-
densation and eventual rust or corro-
sion.
S Check entire unit for loose screws. Re-
place any damaged, worn, or broken
parts.
10