Klarstein Valeria Manual page 19

4 According to the hanging board, drill 12 holes in the ceiling, see pic 2.
12 ST6*40 mm big flat screws will be used to fix the hanging board on the
ceiling, and then 8 M4*10 screws and a M4 nut with gasket will be used to
connect the angle iron into the hanging board, see pic 1. After calculating the
length of the angle iron, 16 M4*10 big flat screws and a M4 nut with gasket
should be used to connect the angle iron and another angle iron (the overlap
length of angle iron can not be less 100 mm).
5 Let one side of the extensible pipe go outside through the hole of 170 mm, see
pic 3.
6 4 ST4*8 big flat screws will be used to connect the internal chimney into the
hanging board. Then put up the external chimney, two hooks will be used to put up
the external chimney in order to the next installation, see pic 4.
7 4 ST4*8 big flat screws will be used to install the outlet, see pic 5.
EN
19