Troubleshooting; Need Assistance - Weed Eater 2500 Series Instruction Manual

STORAGE
WARNING:
Perform the following
steps after each use:
S Stop unit and disconnect from the power
source.
S Allow motor to cool before storing or
transporting.
S Store unit with all guards in place. Posi-
tion unit so that any sharp object cannot
accidentally cause injury.
S Store unit unplugged, well out of the
reach of children.
SEASONAL STORAGE
Prepare unit for storage at the end of the
season or if it will not be used for 30 days
or more.If your blower is to be stored for a
period of time:
S Stop unit and disconnect from the power
source.
S Clean the entire unit before lengthy stor-
age.
TROUBLESHOOTING TABLE
WARNING:
Always stop unit and disconnect from the power source before
performing all of the recommended remedies below except remedies that re-
quire unit to be operating.
SYMPTOM CAUSE
Unit fails to 1. Switch in the OFF position.
operate. 2. Extension cord discon--
nected.
3. Circuit breaker tripped, or
fuse blown.
4. Mechanical failure
Unit
1. Mechanical failure
vibrates
abnormally.
Impeller will 1. Debris in air intake area.
not turn free- 2. Mechanical failure.
ly.
S Open inlet cover and clean any dirt,
grass, or debris that has collected. In-
spect the blower and all tubes. Close and
make sure the cover is latched.
S Clean air vents and air inlet of debris.
S Store your unit and extension cord in a
well ventilated area and covered, if pos-
sible, to prevent dust and dirt accumula-
tion. Do not cover with plastic. Plastic can-
not breathe and
condensation and eventual rust or corro-
sion.
S Check entire unit for loose screws. Re-
place any damaged, worn, or broken
parts.

NEED ASSISTANCE?

Need Accessories or Assistance?
Call: 1-800-554-6723.
Need Service Parts?
Contact your dealer.
ACCESSORIES AVAILABLE
Safety Goggles Stock #952701506
Flex Vac Kit FV1910 #952701627 (used
only on model 2540 and 2560)
REMEDY
1. Slide switch to ON position.
2. Reconnect extension cord.
3. Reset circuit breaker or
fuse.
4. Contact your authorized
service dealer.
1. Contact your authorized
service dealer.
1. Clean unit. Remove any
debris.
2. Contact your authorized
service dealer.
8
may cause