Troubleshooting Table - Weed Eater WE20VB Instruction Manual

ENVIRONMENTALLY SAFE BATTERY
DISPOSAL
The following toxic and corrosive materials
are in the batteries used in this blower battery
pack: Lithium-Ion, a toxic material.
WARNING:
All toxic materials must be
disposed of in a specified manner to prevent
contamination of the environment. Before
disposing of damaged or worn out Lithium-
Ion battery packs, contact your local waste
disposal agency, or the local Environmental
Protection Agency for information and specific
instructions. Take the batteries to a local
recycling and/or disposal center, certified for
lithium-ion disposal.
WARNING:
Always stop unit and disconnect from the power source before performing all
of the recommended remedies below except remedies that require unit to be operating.
TROUBLE
Motor fails to start when
the trigger is depressed.
Unit will not start.
The unit will start, but air will
not flow through the tube.
MAINTENANCE

TROUBLESHOOTING TABLE

CAUSE
1. Battery is not secure.
2. Battery is not charged.
Defective power switch.
Blocked tube.
WARNING:
If the battery pack cracks or breaks, with or
without leaks, do not recharge it and do not
use. Properly dispose of it replace with a new
battery pack. DO NOT ATTEMPT TO REPAIR
IT! To avoid injury and risk of fire, explosion,
or electric shock, and to avoid damage to the
environment:
• Cover the battery's terminals with heavy-
duty adhesive tape.
• DO NOT attempt to remove or destroy any
of the battery pack components.
• DO NOT attempt to open the battery pack.
• If a leak develops, the released electrolytes
are corrosive and toxic. DO NOT get the
solution in the eyes or on skin, and do not
swallow it.
• DO NOT place these batteries in your
regular household trash.
• DO NOT incinerate.
• DO NOT place them where they will
become part of any waste landfill or
municipal solid waste stream.
• Take them to a certified recycling or
disposal center.
REMEDY
1. To secure the battery pack, make
sure the battery is fully secured in the
blower. Refer to the Battery Installation
section in this manual.
2. Charge the battery pack according
to the instructions included with your
model.
Have the power switch replaced by an
authorized service center.
Clear the blockage.
10