Troubleshooting - Brabantia D1S-3T Instruction Manual

TROUBLESHOOTING

Problem
Kettle switches off
automatically before
boiling
The kettle does not work
There is a peculiar smell
inside the kettle
There is dirty water or
water scale inside the
kettle
Solution
1. Check if there is scale build-up. If so, descale
as instructed.
2. Check if there is enough water in the kettle. If
not, boil dry protection will automatically be
activated. To reset the kettle, add cold water
to the kettle and after about 2 mins the
automatic protection device will reset and the
kettle will work.
1. Check if the connecting plug and socket are in
good working order.
2. If the power cord is damaged, it must be
replaced by an original factory part from an
authorised service centre.
3. When the kettle starts to boil dry, the
automatic boil dry protection device will shut
the power off. Reset as above.
1. Occasionally there is an initial odour when the
kettle is used for the first time. Boil and discard
the water a few times before using again.
2. If this problem persists, fill water to the
maximum mark, add two spoons of baking
soda to the water, boil and discard the water
after boiling.
1. Scale build-up is common in hard water areas
and is caused by calcium carbonate and
magnesium carbonate. Descale the kettle
regularly.