Side Burner Maintenance - Weber PLATINUM 2200 NG Operating Manual

SIDE BURNER MAINTENANCE

WARNING: All gas controls and supply valves
should be in the OFF position. Figure 17 (a).
Make sure black wire is connected between igniter and
electrode. Make sure white wire is connected between
igniter and ground. Check that igniter lock nut is tight.
Figure 17 (b) and figure 17 (c).
Note - If the igniter works loose, carefully tighten the
igniter lock nut with an adjustable wrench or pliers.
(a)
White wire
Figure 17
Ground
(b)
Igniter lock nut
Views from
figures 17 (b) and (c)
from under side burner
Black wire
(c)
Electrode
The Platinum Series II side burner has been factory set
for the correct air and gas mixture. The correct flame
pattern is shown in Figure 18.
16
Tips occasionally yellowish
Dark
blue
Figure 18
Light
blue