Advertisement
IMPEDANCE three-way rotary selector. Set this selector to the position that matches the impedance of your speaker cabinet.
NOTE – if you are using two speaker cabinets in parallel (ex – two 16 Ohm cabinets), set the impedance selector to half that of
a single cabinet (in this case, 8 Ohms).
SPEAKERS ¼" speaker cable jacks. Use a ¼" speaker cable to connect your speaker cabinet to the amplifier using these
jacks. If you use one speaker cabinet, it does not matter which jack is used. If you want to run two cabinets in parallel, connect
the second cabinet to the amplifier using the other jack.
NOTE – never turn your amplifier ON without connecting the amplifier to a speaker cabinet or suitable dummy load! Failing to
do so may damage your amplifier!
7
Advertisement
