Monster MLB7-1030 Operation Manual page 5

For horizontal or wall mounted orientations, attach the base
3
in the center of the light bar using the two included screws.
For vertical orientation, route cord through the cord channel
and attach the base at the end of the light bar.
vertical:
Position the IR receiver in a location where it can receive
4
signal from the IR remote. Secure the receiver using the
included adhesive tape if desired.
Remove the tab from the battery compartment of the
5
remote control
Connect the USB cable to a powered USB port or
6
wall charger (1A adapter required – not included)
horizontal or
wall mounted:
to avoid cord damage,
don't pull the cord tight
using the cord channel
makes the vertical
light bar more stable
wall mounted tip:
attach the base to the wall
first using the adhesive tape
or, if desired, a screw and
anchor (not included)
adhesive
screws
this
side
UP