Table of Contents
Advertisement
English
The mounting orientation of the sockets is preset as well. The
markings on the PCB, the socket and the IC must lie on top of
each other after mounting.
Micro-Controler
Micro-controller are ICs, which are individually programmed
for
manufacturer´s
programmed controller normally are only available from the
manufacturer of the circuit belonging to it.
Voltage regulators
Voltage regulators are ICs, which convert a variable, non
regulated input voltage in a constant output voltage. They are
produced in transistor housings with three connecting pins for
input, output and earth.
With voltage regulators in a SOT-housing (in form of a half
cylinder) the mounting orientation is given by the layout of
the connecting pins.
Terminal strips
Terminal strips are solder-in screw-type terminals. They provide a
solder-free and safe connection of the cables to the circuit, which can
still be seperated any time. When several terminal strips have to be
mounted side by side, they have to be put together before mounting.
Assembling the kit
Start the assembly with the lateral resistors and diodes and continue
with the vertical resistors and diodes R2, D4 and D5. First solder the
components on the solder side of the PCB and then cut the excess
wires with the side cutter, as short as possible.
Next solder in the capacitors, the electrolytic capacitors, the voltage
regulator and the IC-sockets. They have to be mounted according to
the marking on the PCB.
Page 34
the
particular
works
application.
When
their
memory
RCD-1
leaving
the
is
empty.
The
Advertisement
Table of Contents
