Check that the igniter is secure in the frame brace and
has not shifted out of the key hole. Figure 15.
If it is loose, slide the igniter into the rear of the key hole.
Carefully tighten the igniter lock nut with an adjustable
wrench or pliers.
Frame brace
Figure 15
(a)
Frame brace
Keyhole in
Igniter lock nut
frame brace
(c)
Small part of keyhole
in frame brace
Check that the tank panel tabs are in their slots in the
frame brace. Figure 16.
(b)
Check that all the burner valves are off.
Valves are shipped in the OFF position, but you should
check to be sure. Put the knob on each valve. Check by
pushing down and turning clockwise. If they do not turn,
they are off, proceed to the next step. Figure 17.
7
Tank panel tabs
Figure 16
Figure 17