Machine Operating Buttons - Janome Memory Craft 9850 Instruction Book

u
y
t
r
e
w
q

Machine Operating Buttons

q Start/stop button
stitches, it then runs at the speed set by the speed control
The button will turn red when the machine is running, and
Pressing and holding this button while sewing will slow
down the sewing speed and the machine will stop when
NOTES:
w Reverse button
When sewing stitch pattern U1, U4, U9, U10, Q1-Q3 or
BR1-5, the machine will sew in reverse as long as the
If stitch pattern U1, U4, U9, U10, Q1-Q3 or BR1-5, has
been selected and the foot control is not connected,
the machine will start sewing in reverse as long as the
If you press the reverse button when sewing any other
patterns, the machine will immediately sew locking
e Auto-lock button
When sewing stitch pattern U1, U4, U9, U10, Q1-Q3 or
BR1-5, the machine will immediately sew locking stitches
and automatically stop when the auto-lock button is
When sewing all other patterns, the machine will sew to
the end of the current pattern, sew locking stitches and
The machine will trim the threads automatically after
locking the stitch when "Thread Cut after Auto-Lock"
r Needle up/down button
However, you can change the needle stop position in the
NOTE:
The LED signal y is turned on when the down position
t Thread cutter button
NOTES:
u blinks when the machine trims
u turns on when "Thread Cut
after Auto-Lock" is ON in setting mode (refer to page
8