Section 4: Using Device Features; On-Device Data Logging And Monitoring - SCT X4 User Manual

Performance, ford/gm/dodge/chrysler/jeep

Hide thumbs Also See for X4:

Quick start manual (25 pages)

Quick start manual (15 pages)

Quick start manual (2 pages)

Table Of Contents

Table of Contents

4.1 ON-DEVICE DATA LOGGING AND MONITORING

This menu accesses the Monitoring and Data Logging feature. This menu is also used

when collecting data from the analog input on the device.

With your key out of the ignition, connect your device to the OBDII port to power on your

X4. Using the down arrow, highlight "Gauges/Datalog" and select it by pressing the center

button on the keypad.

Turn the key to the ON position, and use the left arrow to select "Configuration" at the

bottom of the screen.

Select your vehicle type from the list of Datalog Files provided using the down arrow key and

selecting "Continue".

See "Editing a Gauge" and "Editing Gauge Layout" to configure your display.

Once you have your layout and gauges selected, start your vehicle.

To record, press the center button on the keypad.

To stop/end your datalog, press the left or right button and select "Stop Datalog".

EDITING A GAUGE

To edit a gauge you will tap twice on the gauge you would like to edit. You will be taken to the

edit screen where you can choose what parameter you would like to monitor.

ITEM:

Here you will find a list of parameters that are preloaded on your device. You can find the

Analog Inputs at the bottom of this list.

UNIT:

Based on the item you have chosen from the list, the unit will change to the corresponding

unit of measure. If you are choosing an Analog Input, you will need to select the appropriate preset

equation based on your analog source

EQUATION:

We have preset the most common equations below

• V (this would be Voltage)

• PLX EGT ˚ F

• SensorConnection EGT ˚F

• LM1

• PLX

• AEM

• G100

• GM 1Bar MAP

•GM 3Bar MAP