Toro 30517 Nstallation Instructions page 6

1 2 3
Right Side
1. Light bulb w/double
filament
2. Black wire here
3. Violet wire here
1 2 3
Figure 12
1. Orange wire here
2. Light bulb w/single filament 5. Black wire here
3. Brown wire here
10. Install a lens to each warning light. Make sure the
amber lens on each light is toward the outside of the
machine.
11. Install the cab roof to the headliner with the fasteners
previously removed.
Important: Brake light function not used.
g017760
4 5 6
Figure 11
4. Gray wire here
5. Light bulb w/single filament
6. Blue wire here
g017759
4 5 6
Left Side
4. Light bulb w/double
filament
6. Violet wire here
7
Installing the Wire Harness
Parts needed for this procedure:
1 Wire harness
1 Grommet
13 Cable tie, 7–1/4 inch (184 mm)
2 Cable tie, 14–1/2 inch (368 mm)
Procedure
Route, connect and secure the wire harness as follows:
• Starting at the front of the machine and under the
floor plate, route the end of the harness with the (2)
connectors up through the knockout in the floor
plate and up the steering column to the turn signal
and head light switches. Plug the harness connectors
to the appropriate switches.
1. Knockout plug hole
• Cut a slit in the supplied grommet and cut out the
bottom opening. With the cone end of the grommet
facing down, wrap it around the harness and insert it
into the knockout hole in the platform (Figure 13).
• Route the left and right head light harness connectors
along the front of the platform to each head light
(Figure 14).
• Plug the harness connectors into the head lights and
the harness clips into the holes in the head light
brackets (Figure 14).
• Cable tie the harness to the holes in the frame
gussets.
6
Figure 13
2. Grommet