Advertisement
Table of Contents
2 Ton Aluminum Racing Jack
Gato ge Piso Aluminium 2 Tonnes
Cric Rouleur En Aluminium 2 Tonnes
User' s Manual / Manual de usuarios / Guide de I' utilisateur
WARNING: Cancer and Reproductive Harm
- www.P65Warnings.ca.gov
Maximum capacity
Min. height
Max. height
Dual pump
Handle Length
Saddle diameter
Specifications
2 Tons (4412 lbs.)
3-3/10"
18-1/2"
7 strokes (no load)
47-2/5"
4-1/2"
Front wheel
Rear casters
Length
Width
Height
Weight
KTI63092
dia. 2-1/2" x width 2"
dia. 1-4/5" x width 9/10"
25-3/5"
11-4/5"
5-9/10"
42 lbs.
Advertisement
Table of Contents
Related Manuals for K-Tool KTI63092
Summary of Contents for K-Tool KTI63092
- Page 1 KTI63092 2 Ton Aluminum Racing Jack Gato ge Piso Aluminium 2 Tonnes Cric Rouleur En Aluminium 2 Tonnes User’ s Manual / Manual de usuarios / Guide de I’ utilisateur WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov Specifications Maximum capacity 2 Tons (4412 lbs.)
-
Page 2: Safety Information
The K-Tool 2 Ton Aluminum Double-Piston Hydraulic Floor Jack raises the vehicle quickly, and with a 3-3/10” minimum saddle height, it gets under low-profile vehicles without a problem. It’s made of strong, lightweight, aluminum for easy maneuvering around your garage. Meets ANSI... -
Page 3: Operation
BLEEDING During shipment of your new jack, air may enter into the hydraulic jack system which will cause 1. With the handle installed on the jack, rotate it 2 turns counter clockwise. 2. Have someone or use something to hold down the saddle( 8 ) of the jack. the release valve (located inside Handle Yoke). - Page 4 K-Tool International 1 Year Limited Warranty. K-Tool International Lifting Equipment is warranted to be free from defects in material and workmanship within one year from the date of original purchase. This warranty is extended to the original retail purchaser only. If any jack or service-related item proves to be defective during this period, it will be replaced or repaired, at K-Tool International’s option, without charge.
- Page 5 Parts Lists and Assembly Diagrams 31 32 33 34 Rear Wheel ø12, Nut Link Rod Wheek Arch ø12, Washer ø4x45 Coder Pin M8x45 Hex Bolt Front Wheel Limit Pull-Rod ø8, Nut Left Shaft unit Lift Arm Axle ø10, Washer ø16, C ring ø21*19 Bolt Power unit Rod Link...