Operation - NJD Electronics NJ421 Manual

It is recommended that all building be fitted with smoke
alarms (it is mandatory for new buildings). Ionisation-type
smoke alarms are recommended for buildings where
theatrical fog effects are to be used.

OPERATION

To operate:
Place the NJ421 on a firm flat surface Ensure that the
.
fog outlet (at the front) is not obstructed. Alternatively,
the appliance may be suspended using the attached
hanging bracket. If so, to conform with Health & Safety
legislation, a safety chain will also be required.
Plug the mains lead into a 13 Amp mains socket.
If connecting via an extension lead, make sure that the
lead is rated at 6 Amps or more, and that it is fully
unwound.
Allow the fog machine to warm up. This takes about 5
minutes. When warmed up, the "ready" indicator on the
rear panel will illuminate.
Press either pushbutton on the remote control handset
to operate the machine.
To fill the tank:
Disconnect from the mains supply.
Unscrew the lid, and fill with fog fluid. Replace the lid.
Suitable fog fluids are:
Venü Everyday fluid for low density fog (catalogue
numbers: FL101 for a 1 litre bottle or FL105 for a 5
litre bottle)
Venü Benchmark fluid for medium density fog
(catalogue numbers: FL201 for a 1 litre bottle or
FL205 for a 5 litre bottle)
Venü Extreme fluid for high density fog (catalogue
Page 4