Table of Contents
Advertisement
Base Assembly
1.
Unscrew the Fasten Ring and Base Locking Nut from the Stand Assembly.
2.
Insert the Stand Assembly through the hole in the centre of the Base and twist into
position.
3.
Turn the Stand Base upside down with the Stand Assembly facing the floor and place
the Base Weight (15) to the bottom of the Base. Tighten the Base Weight to the Stand
Base by the fastener and locking screw.
4.
Finally, connect the assembled fan head and stand with the connector screw and nuts,
ensure it's strong enough and all fastenings are sufficiently tight.
SFA12610_IM.indd 5
PARTS & ASSEMBLY
1.
Front Grille
2.
Fan Blade
3.
Fan Blade Screw
4.
Rear Guard Screw
5.
Rear Grille
6.
Motor Shaft
7.
Oscillation Knob
8.
Speed Control
9.
Motor Unit
10. Connector Screw and Nut
11. Inner Pole
12. Height adjust knob
13. Outer Pole
14. Base
15. Heavy Weight
16. Fastener
17. Locking Screw
Fan Grille Assembly
1.
Fasten the rear grille onto
the motor with four screws.
2.
Install the Blade onto the
Motor Shaft by tightening
the blade screw.
Centre the front grille by
3.
aligning the logo on the grille
Hub so it is horizontal and
parallel to the floor.
4.
Secure the front and rear
grilles completely together
by snapping grille clips into
place. Lastly, tighten the grill
e locking screw at the bottom
of the Rear Grille.
5
10/11/2017 11:47
Advertisement
Table of Contents
