Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for iLive H Series
Summary of Contents for iLive H Series
- Page 1 BUILT-IN COOKTOP OPERATING & INSTALLATION MANUAL...
-
Page 2: Safety Precautions
OPERATING INSTRUCTIONS SAFETY PRECAUTIONS Before installing and operating the hotplate, read these instructions completely and carefully. WARNINGS Before using the cooker, read the instructions booklet carefully. This contains very important information IMPORTANT To be installed only by an authorised person concerning safety during installation, use and maintenance. -
Page 3: Operating - Gas Cooktop
OPERATING - GAS COOKTOP PRACTICAL HINTS FOR USE LIGHTING BURNERS – simply press the knob in, turn anti-clockwise to maximum, the electronic igniter will spark and ignite the burner. Check that the gas has been lit; if the burner fails to ignite repeat the above process. -
Page 4: Cooktop Installation Instructions
COOKTOP INSTALLATION INSTRUCTIONS GENERAL Cut Out Dimensions for Built-in H / HF Series 1. The requirements of local Gas and Electrical authorities must be adhered to, Consult AG 601 / ASNZS H360 H60 H39 HF40 5601 and SAA Wiring Rules as appropriate 2. -
Page 5: Installation - Gas Supply
INSTALLATION - GAS SUPPLY Ensure when fitting the elbow supplied with the appliance that the sealing washer is used to These technical instructions have been prepared for use by Authorised persons. This unit must only be prevent gas leaks. installed by an Authorised person. The installation must be carried out by qualified personnel in accordance with the relevant requirements of the Gas Safety Regulations, the local Building Regulations. -
Page 6: Adaptation To Different Types Of Gas
ADAPTATION TO DIFFERENT TYPES OF GAS Burners, Injectors & Mega-joules The cooking hob is supplied as a natural gas unit and should not require any adjustment of the aeration. If the appliance is ordered and specified as a ULPG gas then it will be converted by Eurolinx prior to dispatch and should not require any adjustment to the aeration. -
Page 7: Installation Instructions
INSTALLATION INSTRUCTIONS Minimum flow of cooking hob taps (Figure 1) • Switch on the burner and turn the control knob towards the minimum flow position; • Remove the knob; • Using a screwdriver, adjust the internal screw until the correct low flame is obtained, the screw is located just to the right of the shaft see figure 1 •... -
Page 8: Ancillary Service Information
ANCILLARY SERVICE INFORMATION Pressure Adjustment First turn the gas off to the appliance. Remove the sealing screw from the regulator’s test point at the rear of the appliance and place the hose of the Manometer onto it. Turn the gas on to the appliance and light the Wok Burner and Small Burner at maximum setting. -
Page 9: Cleaning, Care And Maintenance
CLEANING, CARE & MAINTENANCE Cooktops Rangehoods Clean the stainless steel cooktop surface after each use with a clean cloth and normal detergent. Make Rangehood filters need to be washed regularly by using warm soapy water and dried using a soft sure the detergent does not contain chloride or any chloride compound. -
Page 10: Troubleshooting
NOTES TROUBLESHOOTING PROBLEM ANSWER COOKTOPS • Check to see if the brass burners are placed correctly into the aluminium base. This is very important as it will ensure the flame holes line up with the ignition post and spark. It will also ensure correct combustion when alight. - Page 11 Superior Marketing 1870 Bath Ave Suite 3, Brooklyn, NY 11214 Sales Center: 718 249-1215 Service Center: 718 249-1217 sales@superiormktg.com...
Need help?
Do you have a question about the H Series and is the answer not in the manual?
Questions and answers