Advertisement
ALARM LED CODES
If you have an alarm and optional LED(s) installed, it will flash once
a second if armed. If your alarm is triggered then the LED(s) will flash
more than once until it is disarmed. See the table below for what
each LED code represents.
ALARM TRIGGER EVENT
Door, Hood, Trunk, or Ignition On triggered
Full triggered shock sensor
Optional sensor triggered
Panic Mode
To reprogram your remote first cycle the key in the ignition 5 times
within 7 seconds. Parking lights will flash. After that tap the Lock
button on your remote. Repeat for any additional remotes. If you
receive two parking light flashes, your system has exited remote
programming mode and you must retry.
Register online at www.compustar.com within 10 days of purchase to
activate your new remote's warranty.
1W1B_QuickCard line.indd 2
QUICK START CARD
LED FLASHES
2, Pause, Then Repeat
3, Pause, Then Repeat
4, Pause, Then Repeat
5, Pause, Then Repeat
START ERROR CODES
PARKING LIGHT FLASHES
3 then 1
1: Motor running
3 then 2
2: Key in ignition on position
3: Door open
3 then 3
(manual transmission only)
3 then 4
4: Trunk open
3 then 5
5: Foot brake on
3 then 6
6: Hood open
7: Reservation off
3 then 7
(manual transmission only)
3 then 8
8: Tach or voltage sensing failure
3 then 9
9: FT-DAS sensor shutdown
3 then 10
10: System is in Valet Mode
Questions/comments? Contact us at 888-820-3690 from 8
AM to 5 PM PST. Also please visit www.compustar.com for a
complete user's manual.
RF-1WR3R-AM
REMOTE START ERROR
2013/6/6 9:28:50
Advertisement
