Wadia 302 Owner's Manual page 20

20
MUTE
The Wadia 3 3 3 3 02 CD Player has two mute modes that are automatically
implemented under different circumstances.
1. Software Mute: When the MUTE key is pressed on the remote
control, the Wadia 3 3 3 3 02 CD Player DSP engine transmits a stream of
zero signal-level samples to the DAC section, which results in zero
output.
2. Relay Mute: The Wadia 3 3 3 3 02 CD Player has mute relay connected
between the positive and negative outputs. When this relay is
engaged, it connects the positive output to the negative output,
reducing the output to zero. This relay, which produces an audible
click when it engages or disengages, is not in the music signal
path. The mute relay is engaged under any of the following three
conditions:
• Each time the Wadia 3 3 3 3 02 CD Player power switch is turned on.
• When the Wadia 3 3 3 3 02 CD Player detects AC input level below
its minimum operating range.
• When the volume control is set to zero AND the MUTE key on
the remote control is pressed.
When the Wadia 3 3 3 3 02 CD Player is in either software or relay mute, the
Mute indicator on the front panel will illuminate. Note that the CD will
continue playing even when the output is muted.
INPUT
The Wadia 3 3 3 3 02 CD Player can be configured with four optional digital
inputs (See section on Optional Inputs). Each time the INPUT key is
pressed, the next input is selected. For example, if you are listening to
the internal CD drive, and you press the INPUT, Input 1 will be selected.
Press it again, and Input 2 will be selected and so on. After Input 4, the
list will begin again with the internal CD drive.
INVERT
Pressing the INVERT key on the remote control will cause the Wadia 3 3 3 3 02
CD Player to invert phase; pressing it again will switch the phase back
to normal. When the phase is inverted, the INVERT indicator on the front
panel will illuminate.
REPEAT
Pressing the REPEAT key will repeat the entire disc, program, or single
track continuously. Pressing it a second time will stop repeating. The
repeat mode is indicated by the front panel display.