System Takedown - Open Air Cinema CINEBOX HOME SYSTEM User Manual

16
You're all ready to watch your movie, so sit back, relax, and enjoy!
For troubleshooting steps, see next page.
Power down projector by pushing power button on top of projector
or by using remote. Make sure projector cools down completely
before unplugging or turning off power source. Failure to do so
could result in projector or bulb damage.
Turn down all audio and other knobs on mixers and speakers.
Power down all electronic components and neatly coil all cables.
Zip up CineBox™ console. Take down speaker stands and return to
speaker stand cases (for 16' and 20' systems).
Turn off air blower and guide the screen down so that it folds in half
(top to bottom, as shown on step one of screen setup). Unzip the
air vent and disconnect the intake sleeve from air blower. Unclip or
untie tethers from stakes. Remove stakes from ground and clean off
any debris or dirt.
Fold the screen from back to front a few times until it is in a long
strip about two feet wide. Roll tightly and place in protective travel
bag.
ATTENTION: Prevent the projection surface from touching the
ground. Do not pack the screen if it is wet. Hang the screen
indoors if necessary to dry before storage.
WATCH YOUR MOVIE

SYSTEM TAKEDOWN