Advertisement
2
Mounting the Electronic
Controller
Parts needed for this procedure:
1
Mounting bracket
1
Wiring harness
1
Electronic controller (ordered separately)
4
Bolt (1/4 x 1-1/8 inch) (ordered separately)
4
Locknut (1/4 inch) (ordered separately)
Procedure
Note: You can find the electronic controller, bolts, and
locknuts in the Ultrasonic Boom Leveling Kit.
1. Behind the control console, remove the knockout plug
(Figure
6).
1. Knockout plug
Figure 6
2. Control console
2. Remove the 2 bolts and install the mounting bracket to
the machine seat frame
1. Mounting bracket
3. Secure the electronic controller to the mounting
bracket with 4 bolts (1/4 x 1-1/8 inch) and 4 locknuts
(1/4 inch) as shown in
1. Mounting bracket
2. Locknut (1/4 inch)
4. Route the electronic controller terminal of the wiring
harness through the knockout hole.
4
(Figure
7).
Figure 7
2. Bolt
Figure
8.
Figure 8
3. Bolt (1/4 x 1-1/8 inch)
4. Electronic controller
Advertisement
