Advertisement
•
Temperature preset buttons:
Normal mode: the temperature indicator light turns on.
Temperature presets: 50°C→70°C→80°C→90°C→100°C (all lights off)→50°C
Keep warm mode: the temperature indicator light flashes at an interval of 0.5
seconds.
Temperature presets: 50°C→70°C→80°C→90°C→50°C
4. Kettle body LED:
•
The LED will reflect the preset temperature as outlined below:
o
o
o
o
o
•
The LED will turn on in the process of setting the temperature, heating or keeping
warm. When heating has finished, the LED will turn off.
5. Kettle status:
Normal mode:
Power on → alert sounds twice → all indicators light up for 1 second → LED on kettle
•
body flashes red, green, and blue in turn → into standby status (ready for use).
•
After power on, the default pre-set temperature is 100°C. Press the start button to
boil directly. When the water temperature reaches 98°C, the kettle will stop heating
after 8-10 seconds, then return to standby status after sounding the alert tone
twice.
•
If the start button is not pressed after the temperature is set, the corresponding
indicator light will turn off after 15 seconds and the kettle will return to standby
status.
•
When the kettle begins heating after the temperature is set, the relevant indicator
will illuminate. Once the water reaches the preset temperature, the kettle will stop
heating and sound the alert tone twice. The LED on the kettle body turns off and
the relevant indicator light will remain lit for one minute, after which the kettle
returns to its standby state. Boiling water temperature range is +3 degrees.
•
During the heating process, the temperature can be set through the relevant preset
temperature button.
50°C: LED illuminates green
70°C: LED illuminates blue
80°C: LED illuminates purple
90°C: LED illuminates orange
100°C: LED illuminates red
Advertisement
