Troubleshooting - Parkside PDBNP 14 B1 Translation Of The Original Instructions

♦ Place the new gripper jaws (G) into the front
piece of the metal cone (E2) such that the
narrow ends protrude from its opening.
NOTE
► Both gripper jaws (G) must protrude from the
opening flush with each other. We recommend
that you hold the front piece of the metal cone
(E2) vertically, with the gripper jaws (G)
pointing downward.
♦ Insert the expanding mandrel (F) such that its
tips are inside the notch formed by the rear
ends of the gripper jaws (G).
♦ Using both assembly spanners,
screw the front and back piece of the metal
cone (E2, E1) together.
♦ Screw the metal cone (E) back onto the appli-
ance shaft (A) and tighten it using the assembly
spanner . Use the assembly spanner
lock the lock nut (B).

Troubleshooting

Fault
Riveting power too low, some air escapes
from the outlet.
Appliance does not work; compressed air
escapes completely through the outlet.
PDBNP 14 B1
♦ After installing the metal cone (E), check the
distance between the thread and metal cone
(E). It should be approximately 70 mm. You can
use the assembly spanner
aid. If necessary, adapt the measurement by
adjusting the lock nut (B).
and ,
♦ To attach the front connector
the thread (you will feel minor resistance) and
to
tighten it by hand.
♦ Tighten the front connector
assembly spanner
Possible cause
Moving parts jammed
due to dirt.
Pressure supply too low.
Moving parts are jammed
due to material build-up.
as a measuring
B E
ca. 70 mm
, press it onto
using the
.
Remedy
Check the pressure supply filter
for contamination.
Check the pressure supply filter
for contamination.
Lubricate the tool as described
in the instructions.
If necessary, repeat the steps
outlined above.
Lubricate the tool as described
in the instructions.
GB │ IE │
21 ■