Maintenance And Cleaning; Changing The Gripper Jaws - Parkside PDBNP 14 B1 Translation Of The Original Instructions

Maintenance and cleaning

WARNING! RISK OF INJURY!
Disconnect the appliance from the
compressed air supply.
CAUTION!
► Before maintenance, clean off any hazardous
substances that may (due to working
processes) have accumulated on the
appliance. Avoid all skin contact with these
substances. If the skin comes into contact
with hazardous dusts, this can lead to severe
dermatitis.
► The dust and vapours produced by using
the appliance can be hazardous to health
(e.g. cause cancer, birth defects, asthma
and/or dermatitis); it is essential to carry out
a risk assessment in respect of these risks and
to implement corresponding regulatory mech-
anisms.
NOTE
► To ensure correct functioning and long-term
durability of the rivet gun, pay attention to the
following points:
■ Sufficient and continuously intact oil lubrication
is highly important for optimum functioning.
■ Use only the genuine replacement parts recom-
mended by the manufacturer, otherwise you
could put users at danger. In doubt, contact the
Service Centre.
■ Use only accessories and supplies of the sizes
and types recommended by the manufacturer
of the rivet gun.
■ Only clean the appliance with a soft, dry cloth
or with compressed air.
■ Never use sharp or scratchy cleaning agents
under any circumstances.
│ GB │ IE
■ 20

Changing the gripper jaws

Friction can wear out the gripper jaws
happens, replace the worn gripper jaws
the supplied spare gripper jaws
♦ Unscrew the front connector
assembly spanner
you access to the following parts:
A B C
A Appliance shaft
B Lock nut
C Lock washer
E Two-piece metal cone
G Gripper jaws
♦ Unscrew the two-piece metal cone (E) holding
the gripper jaws (G) from the shaft (A), using
the two assembly spanners
necessary.
♦ Using both assembly spanners,
unscrew the front piece of the metal cone from
the back piece (E2, E1). This gives you access
to the following parts:
A B C D
A Appliance shaft
B Lock nut
C Lock washer
D Spring
E1 Back piece of the metal cone
F Expanding mandrel
G Gripper jaws
E2 Front piece of the metal cone
♦ Remove the expanding mandrel (F) and the
worn gripper jaws (G) from the front piece of
the metal cone (E2).
. If this
with
as follows.
using the
, if necessary. This gives
E G
and if
and ,
E1 F G
PDBNP 14 B1
E2