Chicago Electric 93765 Set Up And Operating Instructions Manual page 11

Video inspection system
Table of Contents

Advertisement

Brought to You by www.snapwhole.com
look at the monitor screen to see if
the LED's are on or not.
(See Figure B.)
9.
Push in on the Camera (A) button
if using the C1 Camera Input (K).
Leave the button out if using the C2
Input (L). An image should appear
on the Monitor (2). If not, recheck the
connections. (See Figure B.)
10.
CauTION! Do not
sharply bend the cable;
the cable will be dam-
aged if severely bent.
Carefully remove the camera end of
the Cable (3) out the center of the
reel, as shown in the illustration
above. Thread it through the hook on
the handle.
11.
Securely thread the Camera (1) onto
the end of the Cable (3) if it is not
already connected.
12.
Turn the reel to unwind the Cable
from the reel while gently feeding it
into the pipe, duct, etc. until the Cable
(3) is at the desired depth. DO NOT
FOrCE CaBlE.
rEV 06d; 08l; 09c; 09j
SKU 93765
For technical questions, please call 1-800-444-3353.
NOTE: This product is ideal for
pipes 1-1/2"-4-3/4" inner diameter
with multiple bends.
13.
Adjust the Brightness (E) and Con-
trast (D) on the front of the Monitor
(2). If additional light is needed, push
on the LED Switch (B) on the front
of the Monitor. Adjust the brightness
of the LED lights with the Dimmer
Switch (C). (See Figure B.)
14.
To reel the Cable (3) back in, care-
fully guide the Cable (3) back into the
reel with one hand, while turning the
reel with the other. To prevent dam-
age, do not sharply bend the cable.
15.
When finished, carefully remove the
Camera (1) from the pipe, duct, etc.
Turn off the POWEr Switch (F) on
the front of the Monitor (2). Discon-
nect the alligator clips on the Battery
Cord (5) from the Battery (4). Then,
unplug the Battery Cord from the
Monitor. (See Figure C.)
16.
If necessary, use a disinfectant to
clean the Camera (1), Ball Protector
(9), and Cable (3) after use. Then
dry. Do not immerse the Monitor (2),
Battery (4), Power Adapters (7), or
any other accessory in liquid.
(See assy. Diagram.)
17.
Store the Video Inspection System
in its Carrying Case (6) and keep the
Carrying Case in a clean, dry location
out of reach of children.
Page 11

Advertisement

Table of Contents
loading

Table of Contents