Table of Contents
Advertisement
Brought to You by www.snapwhole.com
TO MONITOr CaMEra
INPuT JaCK (K, l)
MONITOr (rEar VIEW)
VIDEO
VIDEO
DC 12V IN
D C 1 2V IN
CaM1
CaM2
OuT
IN
3.
Set the Monitor (2) on a clean, dry,
flat, level surface capable of support-
ing the weight of the Monitor and its
accessories. If necessary, attach
the Sunshade (8 over the front of the
Monitor to reduce glare.
(See Figure C, and assy. Diagram.)
4.
Plug the Cable (3) into one of the
Camera ports (K, L) on the back of
the Monitor (2).
(See Figures E and F.)
5-1. To Hook-Up With The Battery:
a.
Set the Battery (4A) on a dry sur-
face, on a plate or other flat, stable
surface out of the sun and close
enough for the Battery Cord (5) to
reach the rear of the Monitor (2).
(See Figure C.)
b.
Attach the
BlaCK (–) connector on
the Battery Cord (5) to the BlaCK
(–) terminal on the Battery (4A).
(See Figure C.)
c.
Attach the
rED (+) connector on
the Battery Cord (5) to the rED (+)
rEV 06d
SKU 93765
For technical questions, please call 1-800-444-3353.
TO MONITOr
DC 12 VOlT-
INPuT JaCK (g)
T
C Ou
12 VD
TO VCr
(NOT INCluDED)
5-2. To Hook-Up With The Power
Adapter:
6.
7.
8.
TO CaMEra (1)
terminal on the Battery (4A).
(See Figure C.)
d.
Plug the other end of the Battery
Cord (5) into the DC 12 Volt-Input
Jack on the back of the Monitor (2).
(See Figure C.)
a.
Plug the Power Adapter (7) into the
nearest 120 volt, grounded, electri-
cal outlet.
b.
Plug the end of the Power Adapter's
(7) cord into the DC 12 Volt-Input
Jack on the back of the Monitor (2).
Set the VCR/Camera Switch (H) on
the back of the Monitor (2) to "CaM-
Era". (See Figure B.)
Turn on the
POWEr Switch (F) on
the front of the Monitor (2).
(See Figure B.)
Press the LED Switch (4) to turn the
LED's on. The LED's may not be vis-
ible in a normally lit room. Point the
camera at the front of the monitor and
Figure C
Page 10
Advertisement
Table of Contents
