Assembly & Installation - Danuser G20/40 Owner's Manual

Assembly &
Description
The G20/40 Digger is built to the exacting standards of high quality which have become
Installation
synonymous with the name Danuser. The G20/40 Digger is designed for one-man operation
from the tractor seat to "Dig Holes Sitting Down." The heat-treated straight bevel gear set,
tapered roller bearings, and tubular crane boom form an integrated design to provide utility
Description
and reliability. The G20/40 Digger is designed for 20 to 40 horsepower, Category I three-
Recommended Tools
point hitch, 540 RPM PTO tractors using sway stabilizers. The digger has a 2 inch round
Instructions
spindle for auger attachment. Augers are available in lengths of 29, 33, and 40 inches, and
auger extensions are available in lengths of 7 and 14 inches. Auger diameters range from
4 to 24 inches. Auger diameter must not exceed 24 inches. Danuser augers are built with
special wear-resistant steel on the lower flights, replaceable cutting edges, and replaceable
points. The auger attaches to the gearbox spindle with a special Grade 8 bolt. The shear
bolt is a special Grade 5 bolt and connects the driveline to the gearbox pinion. Read and
understand this manual and the manual for your tractor before attempting to assemble,
install, or operate this post hole digger. If you have any questions, contact your dealer or
Danuser Machine Company, Inc. at (573) 642-2246.
Recommended Tools
· Hammer or mallet
· 3/16" roll pin punch
· Emery cloth (for removal of excess paint)
· 1/2", 9/16", 5/8" and 3/4" wrenches
· 5/16" allen wrench (for fill plug)
= Safety Sign Location
6807
FIG. 2 - G20/40 ASSEMBLY SEQUENCE
8