Charger Operation - Deltran Battery Tender Power Tender Series User Instructions

OUTPUT POWER MODE DETAILS
1. 2 Amp, 6 Amp and 10 Amp CHARGE:. All three of these modes will
charge and maintain a 12 volt battery for long periods of time. This
function is completely automatic and will never over charge your
battery. The charger output power, voltage, and current depends on
the condition of the battery it is charging.
2. POWER SUPPLY: This mode provides low voltage DC current of ten
(10) Amp at 12.8 volts. The Power Supply function is for use as only a
memory saver when changing out a battery.
3. WARNING/ERROR LED: There are safety timers built into the charger
which vary depending on which battery type you have selected and
also the charge rate. These timers will prevent a bad battery from being
over charged if it does not reach optimum voltage within these time
frames. Have your battery checked if this occurs. This LED also
indicates if the charger alligator clips are connected backwards to the
battery (reverse polarity).

CHARGER OPERATION

1) POWERING UP: When you first plug the charger into a power outlet,
all of the LED's and battery level lights will illuminate for about two (2)
seconds. The charger is set to default to standard chemistry and 2
Amp mode. The battery level lights along with the Standard LED will
continue to flash until the charger is connected to the battery.
2) CHARGE RATE: To select a charge output mode, (example 6Amp)
simply press the charge rate button to change the charge rate and
scroll through the selections. This must be done before you connect to
a battery. Once connected to a battery you cannot change the rate. To
change the charger rate simply disconnect one (1) of the alligator clips.
3) BATTERY CHEMISTRY/POWER SUPPLY SELECT: To change the
battery chemistry or select the power supply, a press the Chemistry
PWR Supply button to scroll through the selections. This must be done
before you connect to a battery. Once connected to a battery you
cannot change the battery chemistry. To change the battery chemistry
simply disconnect one (1) of the alligator clips.
5
4) 2 Amp, 6 Amp and 10 Amp CHARGE/MAINTENANCE: The alligator
clips must be connected to the battery to start the charge cycle. When
the clips are connected, the battery level indicator will illuminate to
show the state of charge. The Battery Chemistry LED will turn on solid
and the battery level lights will begin to illuminate from left to right
indicating a charge is in progress, the far right GREEN LED will turn
solid and remaining LED's will turn off when the battery is fully charged
and in maintenance mode.
5) POWER SUPPLY: To start the Power Supply mode, press the
Chemistry/PWR Supply button until the Power Supply LED is
illuminated. Connect the charger alligator clips to the vehicle battery
cables before you remove the battery.
6) WiFi: When AC power is applied to the charger the WiFi will
automatically turn itself on. If you wish to turn the WiFi off, take a paper
clip and pass it through the reset opening and hold the button down for
three (3) seconds and then release. The blue WiFI LED will also go off.
To turn the WiFi back on simply turn the AC power off then back on
again. The blue WiFI LED will slowly flash until connected to a network.
Once connected the WiFi LED will be solid on. To reset the WiFi
network connection configuration, hold the button down for ten (10)
seconds and then release. (see next diagram)
6