Advertisement
Quick Links
Manufacturer is not responsible for negligent use of vehicle with mud flaps installed, including
over-tightening of screws and bolts causing damage to vehicle or mud flaps.
TOOLS REQUIRED-
Electric or re-chargeable
Drill
FLAPS
(1)Flap Assembly,
Front, DS
Part #766543
PARTS BAG # 766550
a) (2) Screw, Machine
SS, #18-8, 10-24 x 1" Hex
Part #012022
INSTALLATION
(For ease of installation it is suggested that the wheel be removed)
1. Before you install your Mud Flap Set, see the diagram and parts list for all necessary parts. Start on the driver's
side.
2. Remove the factory screws on the inner fender.
3. Loosely install the mud flap through holes #1 & #2 into the factory holes #4 & #5 using (2) factory screws and (2)
stainless steel washers. (See Diagram)
May 13, 2020
IMPORTANT:
¼" Drill Bit
b) (8) Washer, Flat
0.203" x 1" 18g SS
Part #018031
2015-2018 Ford Edge
Mounting Diagram & Instructions
766627 / 766538 / 766633/ 766639
OR
Socket or Open Wrench
(1)Flap Assembly
Front, PS
Part #766544
c) (2) Washer, Lock
18-8SS, 10 Helicoil
Part #024001
Page 1 of 2
Mud Flap Set, Rear
GCR43R
Phillips Screw Driver
d) (2) Nut, Hex
SS, #10-24
Part #025003
Advertisement
Related Manuals for Gatorback Mudflaps GCR43R
Summary of Contents for Gatorback Mudflaps GCR43R
- Page 1 Page 1 of 2 2015-2018 Ford Edge Mud Flap Set, Rear Mounting Diagram & Instructions GCR43R 766627 / 766538 / 766633/ 766639 IMPORTANT: Manufacturer is not responsible for negligent use of vehicle with mud flaps installed, including over-tightening of screws and bolts causing damage to vehicle or mud flaps.
- Page 2 Page 2 of 2 4. With a square or other levelling tool, ensure that the flap is level. 5. Carefully tighten all screws and double-check that the flap has remained level. 6. With a ¼” drill bit, drill through the inner mud flap hole #3 and through the plastic liner #6. 7.