Eastwood 31638 Instructions Manual page 18

TROUBLESHOOTING
PROBLEM CAUSE
Dirt accumulation on moving parts of
machine
Inadequate air supply
Poor/Sluggish
Mounting
Wheel not properly mounted
Machine
Performance
Tire bead not lubricated
Damages wheel or tire
Wheel not properly mounted
Tire bead not lubricated
Excessive or
Unusual Noise
or Vibration
Damaged wheel or tire
Machine not securely fastened to floor
Wheel not properly mounted
Bead Area of
Tire is Torn
Tire bead not lubricated
by Machine
on Mount or
Damaged or missing Plastic Glides
Dismount
Damaged wheel or tire
Bead Area of
Wheel not properly mounted
Wheel Rim
Scraped or
Scratched Damaged or missing Plastic Glides
by Machine
on Mount or
Damaged wheel or tire
Dismount
Plastic Guides
are Wearing
Rapidly Mount/Dismount Shoe not adjusted
Requiring
properly
Frequent
Replacement
18
CORRECTION
Clean and lubricate all sliding/pivoting parts.
Make sure that a constant 115 to 145 PSI [8 to 10 Bar] air supply is available to
power machine.
Remove wheel from Clamping Jaws and remount making sure that all Jaws are
clamping evenly and the Wheel is level on the Turntable.
Add liberal amount of soapy solution or tire bead lubricant to tire bead.
Inspect Wheel and/or Tire for bent or otherwise damaged condition and reject
if found.
Remove wheel from Clamping Jaws and remount making sure that all Jaws are
clamping evenly and the Wheel is level on the Turntable.
Add liberal amount of soapy solution or tire bead lubricant to tire bead.
Inspect Wheel and/or Tire for bent or otherwise damaged condition and reject
if found.
Securely fasten Machine to floor.
Remove wheel from Clamping Jaws and remount making sure that all Jaws are
clamping evenly and the Wheel is level on the Turntable.
Add liberal amount of soapy solution or tire bead lubricant to tire bead.
Inspect and replace Plastic Guides.
Inspect Wheel and/or Tire for bent or otherwise damaged condition and reject
if found.
Remove wheel from Clamping Jaws and remount making sure that all Jaws are
clamping evenly and the Wheel is level on the Turntable.
Inspect and replace Plastic Guides.
Inspect Wheel and/or Tire for bent or otherwise damaged condition and reject
if found.
Follow Mount/Dismount adjustment procedure starting on page 15.
Eastwood Technical Assistance: 800.343.9353 >> techelp@eastwood.com