DeWalt DCS355 Instruction Manual page 15

• Usecoarse gritpaper t o sandrough surfaces, medium grit
forsmooth surfaces andfinegritforthefinishing surfaces. If
necessary, first m ake a test r unonscrap material.
• Excessive force willreduce t heworking e fficiency andcause
motor o verload. Replacing theaccessory regularly will m aintain
optimum w orking efficiency.
• Donotallow thesandpaper to wear a way, it willdamage the
sanding pad.
• Ifthe tool o verheats, especially when used atlowspeed, setthe
speed t omaximum and run itwith noload for2-3minutes tocool
themotor. Avoid prolonged usage a tvery lowspeeds. Always
keep theblade s harp.
MAINTENANCE
_ WARNING: To reduce the risk of serious personal injury,
turn tool off and remove the battery pack before making any
adjustments or removing/installing attachments or accessories.
An accidental start-up can cause injury.
Cleaning
i_,WARNING: Blow dirt and dust out of all air vents with clean, dry air
at least once a week. To minimize the risk of eye injury, always wear
ANSI Z87.1 approved eye protection when performing this.
i_ WARNING: Never use solvents or other harsh chemicals for
cleaning the non-metallic parts of the tool These chemicals may
weaken the plastic materials used in these parts. Use a cloth
dampened only with water and mild soap. Never let any liquid get
inside the tool,"never immerse any part of the tool into a liquid.
CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect the charger from the AC
outlet before cleaning. Dirt and grease may be removed from the
exterior of the charger using a cloth or soft non-metallic brush. Do not
use water or any cleaning solutions.
Accessories
i_WARNING: Since accessories, other than those offered by
DEWALT, have not been tested with this product, use of such
accessories with this tool could be hazardous. To reduce the risk of
injury, only DEWALT recommended accessories should be used with
this producL
Recommended accessories for use with your tool are available
at extra cost from your local dealer or authorized service center. If
you need assistance in locating any accessory, please contact
DEWALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD
21286, call 1-800-4-DEWALT (1-800-433-9258) or visit our website:
www.dewalt.com.
COMPATIBLE ACCESSORIES
Oscillating Sanding Pad
Oscillating Wood with Nails Blade
Wide Titanium Oscillating Wood with Nails Blade
Oscillating Hardwood Blade
Oscillating Fastcut Wood Blade
Wide Oscillating Fastcut Wood Blade
Oscillating Wood Detail Blade
Oscillating Titanium Metal Blade
Oscillating Semicircle Blade
Oscillating Titanium Semicircle Blade
Oscillating Flush Cut Blade
14