DeWalt DCS355 Instruction Manual page 10

b.Check t osee ifreceptacle isconnected toalight s witch w hich
turns power offwhen y outurn outthelights;
c.Move thecharger andbattery p ack toa location where t he
surrounding airtemperature is approximately 65 °F-75°F
(18°-24 ° C);
d.Ifcharging problems persist, take thetool, b attery p ack and
charger toyour l ocal service center.
5.The battery p ack should berecharged when itfails toproduce
sufficient power onjobswhich were easily d one previously. DO
NOTCONTINUE to useunder t hese conditions. Follow the
charging procedure. You may also charge a partially used pack
whenever youdesire w ith noadverse effect onthebattery pack.
6.Foreign materials ofa conductive nature s uch as,butnotlimited
to,grinding dust, m etal chips, steel wool, a luminum f oil, o rany
buildup o fmetallic particles should b ekept a way from charger
cavities. Always unplug t he charger from thepower supply when
there isnobattery pack inthecavity. Unplug thecharger before
attempting toclean.
7.Donot f reeze orimmerse the charger inwater orany other liquid.
WARNING: Shock hazard. Don't allow any liquid to get inside the
charger. Electric shock may result.
i_,WARNING: Bum hazard. Do not submerge the battery pack in
any liquid or allow any liquid to enter the battery pack. Never attempt
to open the battery pack for any reason. If the plastic housing of the
battery pack breaks or cracks, return to a service center for recycling.
Storage Recommendations
1. The best storage place is one that is cool and dry, away from
direct sunlight and excess heat or cold.
2. For long storage, it is recommended to store a fully charged
battery pack in a cool dry place out of the charger for optimal
results.
NOTE: Battery packs should not be stored completely depleted of
charge. The battery pack will need to be recharged before use.
SAVE THESE INSTRUCTIONS
FOR FUTURE USE
FIG. 2
F
G
COMPONENTS (Fig. 2)
i_ WARNING: Never modify the power tool or any part of it. Damage
or personal injury could result.
A. Variable speed trigger
B. LED worklight
C. Accessory clamp lever
D. Lock on/off button
E. Accessory side mount
F. Cut guide block
G. Cut guide arm
H. Battery pack
I. Battery release button