Trouble Shooting - Toshiba AW-J750APH Owner's Manual

MAINTENANCE

Trouble Shooting

If the appliance does not start or it stops during the operation, initially try to find a solution
to the problem based on the table below.
Description
No washing
No water flows in
Abnormal draining If the end of the water drain hose is placed very high.
Abnormal spin
Description
Alarm for abnormal
E1
water
Alarm for water un nished
E2
water draining
Alarm for lid
E3
before wash and spin.
E4 Unbalanced wash load
during spinning
E7-1
Abnormal behavior
E7-2 with dangerous fault.
(brake wires,brake,sensors)
E7-3
E7-4
E7-5
FXX
Others
Note!
• After the checking, try to use the appliance again ,If problems persist or the
display shows other alarm code again, contact the service center
• E1-E4 alarm clear on some models need to be stimulated by "Start" button
If the power is o .
If the water volume reach
not work if the water amount does not reach the required water level)
If it is set to " Preset " washing mode. (It will only start to work until the
reservation time reached) is
If the power is o or the fuse is burned out.
If the water supply is cut o or the water pressure is too low.
If the inlet hose is properly connected and the water tap is opened.
If the ltering screen of inlet valve is blocked by dirt.
If the "Start / Hold" button is pressed after the power switch is pressed.
If the end of water drain hose is immersed in and blocked by a pool of water .
If the top lid is closed.
If most of the clothing are at one side of the drum or if too many
clothes are loaded in the machine.
If the washer is not placed in stable condition or it is placed
state. (The ground is not at).
Reason
lling .
that is not closed
Otherwise, contact the service center.
Inspection Items
the required water level.(The washer will
Solution
Check the water tap is if
opened or not.
Check the water level
sensor and drain pump.
Close the lid.
Evenly distribute the clothes in
the drum by hand.
E7-1 E7-2 E7-3 E7-4 E7-5 appears after
pressing the power button,Please call
for service.
If E7-1 E7-2 E7-3 E7-4 E7-5 appears
during the operation , press the power
button to restart the machine.
Try to look for solutions first then call
for service, if no solutions work.
10
20
an inclined
.
.