Advertisement
again displays the "KL" keel offset setting.
This can be set so that the depth sounder
either shows the depth below the keel or the
depth below the transducer.
Press the up or down arrow keypads to
adjust the reading to set so that the depth
sounder either shows the depth below the
keel or the depth below the transducer.
Press the up or down arrow keypads to
adjust the reading to the desired depth no
more than 19.9 ft.
For example if the bottom of the keel is 2
feet below the transducer and you want the
depth sounder to read the depth below the
keel, the display should be adjusted to read
2.0 FT.
Press and Hold
the "Mode"
button for 3
seconds to turn
off the Depth
Sounder.
(The Temperature
will still display until
Power Off.)
For technical assistance, contact Faria Beede Instruments - Customer Service between
8:30 AM and 5:30 PM Eastern time weekdays at (860) 848-9271 or (800) 473-2742.
Display Sequence
Quick Press
MODE
the "Mode"
button to move
between the
screens.
Note:
Once a keel offset is programmed, the depth
below the keel will activate the shallow and
deep alarms.
Units
Pressing the "ON / OFF MODE" keypad
again displays "Un" on the LCD indicating
the units mode.
Press either the up or down arrow keypads
to set the units desired to feet (FT), meters
(M), or fathoms (F). These units once set,
will remain the same for all modes. Pressing
the "ON / OFF MODE" keypad again returns
the depth sounder to normal operation.
Depth and
Water Temperature
Use the "Up" or "Down" buttons
UP
MODE
to change settings.
DN
Use the "Up" or "Down" buttons
UP
MODE
to set the Shallow Alarm depth.
DN
Use the "Up" or "Down" buttons
UP
MODE
to set the Deep Alarm depth.
DN
Use the "Up" or "Down" buttons
UP
MODE
to adjust the Keel Of
DN
US Standard Units.
Use the "Up" or "Down" buttons
UP
MODE
to change between unit types.
DN
Depth and
Air Temperature
fset.
Metric Units.
Advertisement
