Advertisement
Note: TS0101 and TS0103
are functionally the same.
TS0103 comes with only 5
feet of lead wire (Signal and
Ground). Use TS0103 (if
equipped) for the Air Temp
connection where the lead
does not need to reach farther
than under the dash panel.
Air Temp. Sensor
TS0101/TS0103
White
(Sensor Signal)
Black & Shield
(Ground)
Water Temp. Sensor
TS0101
White
(Sensor Signal)
Black & Shield
(Ground)
WARNING
The depth sounder is not to be used for
navigation or as a device to avoid grounding
which may result in boat damage or
personal
injury. Always
operating in shallow areas and maintain a
very slow speed. Be aware that depths may
change too quickly for you to react and avoid
grounding.
CAUTION
Disconnect the battery during installation.
Tighten nuts on the back-clamp only slightly
more than you can tighten with your fingers.
Six inch-pounds of torque are sufficient.
Over-tightening could result in damage to
the instrument and may void your warranty.
Installation
1.
It is recommended that insulated wire
terminals, preferably ring type, be used on
all connections to the power source.
2.
Cut a 2-1/16" diameter hole in the dash
and mount the gauge with the back clamp
supplied.
3. Mount the Water temperature sensor as
low as possible on the transom or where it is
best to get the temperature of the water you
would like to monitor. (i.e. Bait Well)
4. Mount the Air temperature sensor
anywhere in the boat other than the engine
compartment. For best results place sensor
Purple(+ )
Black (-)
Red
(Air Temp Sig)
Black
(Signal ground
White
(Water Temp Sig)
Black
(Signal ground
use
caution
)
)
away from direct sun light.
5.
Connect any one of the black wires to
the boat's electrical ground, usually
available at several locations near the
instrument panel.
6. Connect the purple wire to a 12 Volt DC
circuit that is activated by the ignition
switch.
7. Connect a second black wire to the
water temperature sensor ground.
8. Connect the white wire to the water
temperature white sensor signal wire.
9. Connect a third black wire to the air
temperature sensor ground
10. Connect the red wire to the air
temperature white sensor signal wire.
11. Once the transducer is installed and
you have lead the cable to the depth
sounder, connect the three wires (black,
blue, and bare) from the transducer to the
corresponding
connector plug using the butt connectors
supplied. (See Illustration above)
Note:
1)
The bare and black wire from the
transducer will need to be twisted together
and then both connected to the black wire of
the plug.
colored
wires
of
the
Advertisement
