Operating; Changing The Battery - Westfalia RTS-1200W Instruction Manual

4. Connect the receiver, as shown in the connection diagram. Also see fig. 1 on
page III. If necessary, use suitable junction boxes to connect the cords.
Brown/black = L Phase
Blue = N Neutral Conductor
Green-Yellow = Earth Conductor
Using
1. On the remote control, press the button ON in order to switch on the
consumer load.
2. By pressing the button OFF you will switch off the consumer load.
ATTENTION!
Before undertaking any connection or maintaining work e. g. changing
the illuminant, due to the single-pole cut-off and the commonly used
transmission frequency, the input lead of the connected consumer load
has to be voltage-free! To switch off the unit with the remote control is
not enough.

Changing the Battery

1. Open the battery compartment (G) on the rear of the remote control and
insert one battery of the type A23, observing the right polarity. The polarity
symbols are marked inside the battery compartment.
2. Close the battery compartment until it locks audible.

Operating

Rear
10
Consumer
Load